Sea gull lighting 75250-758 Guia de Instalação

Consulte online ou descarregue Guia de Instalação para não Sea gull lighting 75250-758. Sea Gull Lighting 75250-758 Installation Guide Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
ASSEMBLY
GENERAL
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF.
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Under no circumstances should a fixture be
hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system.
Read instructions carefully.
If you are unclear as to how to proceed,
consult a qualified electrician.
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1 & 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
GREEN
GROUNDING SCREW (D)
*OUTLET BOX
SCREWS
MOUNTING
BAR (A)
*WIRE
CONNECTORS
MOUNTING
SCREWS (I)
*GROUND WIRE
*OUTLET BOX
GROUNDING AND MOUNTING BAR LOCK UP
FIGURE 2
*NOT INCLUDED
FIGURE 1 *NOT SUPPLIED
*OUTLET
BOX
FIXTURE
MOUNTING
SCREWS (I)
*WIRE
CONNECTORS
LOCK
WASHER (F)
MOUNTING
BAR (A)
*OUTLET
BOX SCREWS
CANOPY (E)
NUT (B)
CAP NUT (F)
IF SUPPLY WIRES ARE LOCATED
WITHIN 3” OF BALLAST, USE WIRE
RATED FOR AT LEAST 90˚C.
CENTER
PIPE (G)
DIFFUSER (H)
DECORATIVE CAP (L)
BALL FINIAL (J)
NUT (K)
RUBBER
WASHER (P)
Installation And Safety
Instruction
HC-673
031803
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Instruction

INSTALLATION AND SAFETY INSTRUCTIONSFOR YOUR SAFETYASSEMBLYGENERALWARNING: BE SURE THE ELECTRICITY TO THE WIRES YOUARE WORKING ON IS SHUT OFF. EITHER

Página 2 - POWER SUPPLY WIRES

Install lamps.Raise diffuser (H) to canopy so that center pipe (G) protrudesthrough hole. Secure in place with rubber washer (P) and nut (K).Install

Comentários a estes Manuais

Sem comentários