Sea gull lighting 4702-962 Guia de Instalação descarregar pdf

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully. If you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1. Be careful not to misplace any of

the screws or parts which are needed to install this fixture.

Peel protective coating off as follows: (if applicable). For easier

removal, peel coating off at an angle holding it close to the fixture.

Peel sides off before peeling the front faces.

STEP 1:

*NOT SUPPLIED

FIGURE 1

*NOT SUPPLIED

FIGURE 2

* WIRE

CONNECTOR

FACE PLATE

CUPS (I)

FACE PLATE (F)

GCO GROUND WIRE

(IF APPLICABLE)

*ROMEX/BX

CONNECTOR

BACK PLATE

Installation And Safety

Instruction

HC-107

100101

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

DECORATIVE

FRONT (E)

* OUTLET BOX

GROUND WIRE (D)

* OUTLET BOX

* WIRE

CONNECTOR

BACK PLATE (C)

SOCKETS (J)

EXTRUDED HOLE (B)

GREEN GROUNDING

SCREW (A)

WOOD

SCREWS (K)

NOTE: SOCKETS ARE FACTORY INSTALLED.

IF SOCKET IS NOT SECURE TO BACKPLATE, MAKE

SURE SOCKET TABS ARE SNAPPED ONTO

PRE-DRILLED HOLES IN BACKPLATE.

1 2

Resumo do Conteúdo

Página 1 - Instruction

INSTALLATION AND SAFETY INSTRUCTIONSFOR YOUR SAFETYASSEMBLYGENERALWARNING: BE SURE THE ELECTRICITY TO THE WIRES YOUARE WORKING ON IS SHUT OFF. EITHER

Página 2 - POWER SUPPLY WIRES

Position faceplate (F) or decorative front (E) over sockets (J). NOTE:If backplate (C) is supplied with mounting studs (H) positionfaceplate over stud

Comentários a estes Manuais

Sem comentários

Sea gull lighting 4702-962 Guia de Instalação

Consulte online ou descarregue Guia de Instalação para não Sea gull lighting 4702-962. Sea Gull Lighting 4702-962 Installation Guide [en] [es] [ja] [zh] Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com não Sea gull lighting 4702-962